Stafford Little League: 2009 Bat Rules
 | |
 | |
What is changed: Reduces the maximum diameter for a bat in the Junior League Baseball division from 2 3/4 inches to 2 5/8 inches. (Maximum diameter for bats in Senior League and Big League remains at 2 5/8 inches.)
1.10
The bat must be a baseball bat which meets Little League specifications and standards as noted in this rule. It shall be a smooth, rounded stick and made of wood or of material and color tested and proved acceptable to Little League standards.
Little League (Majors)and below:
It shall not be more than thirty-three (33) inches in length nor more than two and one-quarter (2¼) inches in diameter. Non-wood bats shall be printed with a BPF (bat performance factor) of 1.15 or less;
Junior League:
It shall not be more than 34 inches in length; nor more than 2 5/8 inches in diameter, and if wood, not less than fifteen-sixteenths (15/16) inches in diameter (7/8 inch for bats less than 30”) at its smallest part.
Senior/Big League:
It shall not be more than 36 inches in length, nor more than 2 5/8 inches in diameter, and if wood, not less than fifteen-sixteenths (15/16) inches in diameter (7/8 inch for bats less than 30”) at its smallest part. The bat shall not weigh, numerically, more than three ounces less than the length of the bat (e.g., a 33-inch-Iong bat cannot weigh less than 30 ounces). All non-wood bats shall meet the BESR performance standard, and such bats shall be labeled with a permanent certification mark.
In all divisions, wood bats may be taped or fitted with a sleeve for a distance not exceeding sixteen (16) inches (18 inches for Junior/Senior/Big League baseball) from the small end. A non-wood bat must have a grip of cork, tape or composition material, and must extend a minimum of 10 inches from the small end. Slippery tape or similar material is prohibited. An illegal bat must be removed.
NOTE 1:
Junior/Senior/Big League: The 2¾ inch in diameter bat is not allowed in any division.
NOTE 2:
The traditional batting donut is not permissible
NOTE 3:
The bat may carry the mark “Little League Tee Ball.”
NOTE 4:
Non-wood bats may develop dents from time to time. Bats that cannot pass through the approved Little League bat ring for the appropriate division must be removed from play. The 2¼ inch bat ring must be used for bats in the Tee Ball, Minor League and Little League Baseball divisions. The 2 5/8 inch bat ring must be used for bats in the Junior, Senior and Big League divisions of baseball.
Additional Information for Little League Baseball (Majors) and Below
In effect for the 2009 season is the requirement that all non-wood bats used in Little League Baseball (Majors) Divisions and below shall be printed with a BPF of 1.15 or less.
This stipulation has been included in the Official Rules and Regulations for the past few years, leading up to 2009, so that leagues, parents, and bat manufacturers could prepare for it.
Most non-wood bats manufactured over the past several years for the age groups involved in Little League Baseball (Majors) and below have been permanently imprinted with the BPF. In fact, very few bats sold today with a diameter of 2-1/4 (two and one-quarter) inches are not printed with the BPF rating.
So, starting with the 2009 season, bats printed with a BPF higher than 1.15, or without a BPF printed (or not legible) on the bat, are not permitted in these divisions.